How to Locate an Attach ID
How to Locate an Attach ID
The Attach ID of your bridge will be located on a sticker affixed to the top of your unit. If this label is missing or a label wasn't provided, please follow the steps below to recover your Attach ID.
Using a Monitor connected to the bridge
- Connect an HDMI monitor and a USB keyboard to your bridge/CMVR.
- You should be presented with a login prompt - if not, press Q on your keyboard
- Enter the username as admin, press the Enter key
- Password will be the last 5 of the serial number
- From the menu select System Info and press the Enter key
- Locate the Attach ID in the list
Using Putty
This option requires Windows
- Download and install Putty (<<< click on Putty to download)
- Ensure your laptop's network interface is set to DHCP
- Connect your laptop directly into the CamLAN port of the bridge/CMVR
- Run Putty
- Type 10.143.0.1 into the Host Name bar
- Type 22 into the Port Name bar
- You may receive a PuTTY Security Alert, select No
- Enter the username as admin, press the Enter key
- Enter the password which is the last 5 digits of your bridge serial number (EEN-BR***-12345) and press the Enter key
- Select System Info and press the Enter key
- Locate the Attach ID in the list
Do not worry if your bridge login screen does not look like the video.
There are different versions of the Local Configuration Utility which will show the Attach ID on the initial load screen.
For support please email: support@een.com
or give us a call at: 512-473-0501
Eagle Eye Knowledge Base
US: +1-512-473-0501
EU: 31 (0) 20 26 10 460
ASIA PACIFIC: +81-(3)-6869-5477
#1 In Cloud Media Video Surveillance Worldwide
Copyright Eagle Eye Networks. All rights reserved.
Related Articles
アタッチIDはどこで確認できますか
アタッチIDはブリッジに同梱されたラベルに記載があります。もしラベルが無い、またはアタッチIDの記載が無い場合は、以下の手順によってアタッチIDを確認する事ができます。 ブリッジにモニター及びキーボードを接続する場合 HDMIモニターとUSBキーボードをブリッジまたはCMVRに接続します。 ログインプロンプトが表示されます。 Usernameにadminを入力し、Enterキーを押します。 ...
Bridge Swap Guide
Bridge Swap Guide The bridge swap process allows you to replace your offline bridge with a new unit without losing your camera recordings. When swapping a CMVR, please contact Support to ensure data is retained, if possible. The process consists of ...
Adjusting Network Settings on an Eagle Eye Bridge
Adjusting Network Settings on Eagle Eye Networks Bridge By default, all of our devices are configured fully DHCP (for WAN and CamLAN). In order to reconfigure these settings you will need a keyboard and monitor. If you see cameras displayed on the ...
Bridge Configurator Menu Guide
Bridge Configurator Menu Guide The Bridge Configurator Menu is available on CMVRs This guide describes what options exist in the Bridge Configurator Menu in order to connect to a bridge. For detailed instructions for troubleshooting offline bridges, ...
Connecting to a Bridge/CMVR
Connecting to a Bridge/CMVR There are 3 ways to connect directly to the bridge/CMVR: Note: if a bridge fails to reach the login screen a HMDI monitor and USB keyboard will be required. A usb keyboard and a monitor with an hdmi cable A usb cable and ...