ANV082 Using Customer-Supplied SIM Cards with Brivo Eagle Eye Cabinet Systems

ANV082 Using Customer-Supplied SIM Cards with Brivo Eagle Eye Cabinet Systems

Application Note: Video - ANV082

Using Customer-Supplied SIM Cards with Brivo Eagle Eye Cabinet Systems

2025-06-30   Revision 1.0


Target Audience


This Application Note is intended for users of Brivo Eagle Eye Cabinet Systems who prefer to supply their own SIM card and cellular plan rather than the card and service provided via Brivo.


Introduction


The router in the cabinet system has two SIM card slots for two channels. To set up the router with a SIM card, users need an activated SIM card from a cellular provider, a computer with a LAN cable, and direct physical access to the cabinet system.


The step-by-step instructions are listed in the following sections.


InHand Cellular Setup

Follow the instructions in this section to correctly set up the router on a Brivo Eagle Eye Cabinet System with a SIM card.

  1. Connect the laptop to one of the Ethernet ports on the “inhand” router. Open a web browser and navigate to http://192.168.2.1


  1. Enter the username and password. The username is adm. The password will be the router's serial number followed by an exclamation mark.  (e.g., RF3022319236617!) Older units (manufactured before June 2024) might have the password of Eagle23soaring.


  1. You should see the message: Login successfully.


  1. The following screen opens.


  1. Click Services, then Device Manager.


  1. Verify that the Device Manager is enabled with the server set to iot.inhandnetworks.com. There should already be an een.com email account, but if not, enter cellrouter@een.com to connect to Eagle Eye’s management service. Click Apply.


  1. Next, click Network, then Cellular.

  1. The following screen opens.

  1. Ensure that the box for Dual SIM Enable is not checked. Change the SIM1 Network Provider setting to the provider you plan on using. Click Apply to save and restart the services.


Conclusion


After these few steps, the router is active and set for the Network Provider you set.  


For additional information, the Quick Start Guide for the inhand cellular router can be found here IR302 Quick Start Guide


Use the figure below and Table 1 to verify your router's status.


LED Indicator Description


Table 1: Equipment LED Light Description Table

Power (Red)

Status (Green)

Cellular (Yellow)

Definition

Off

Off

Off

No Power

On

Off

Off

System Fault

On

On

Off

Module or SIM Card not identified

On

On

Flash

Dialing

On

On

On

Dialing Success

On

Flash

On

System Upgrade

On

Flash -> On

Off

Finalized Writing -> Finalized Writing


Note:

Signal

Red

Signal values 0~10

Yellow

Signal value 11~20

Green

Signal value 21~30

Wi-Fi

(Green)

Not enabled

Off

AP

Flash

STA

Flash