ANV079 Axis Thermal Camera Events in Brivo Eagle Eye Video: A How-To Guide

ANV079 Axis Thermal Camera Events in Brivo Eagle Eye Video: A How-To Guide

Application Note: Video - ANV079 

Axis Thermal Camera Events in Brivo Eagle Eye Video: A How-To Guide

2025-01-14   Revision 1.0


Target Audience


This Application Note is intended for Brivo Eagle Eye Video account administrators responsible for VMS setup and configuration who want to install Axis thermal cameras. 


Introduction


This document details how to configure an Axis thermal camera in Brivo Eagle Eye Video. By following this guide, users can get the thermal Events from the camera to show up in History Browser and Alerts/Notifications. The features mentioned below are supported for the thermal camera:  

  1. Filter for thermal events (thermal threshold crossed)

  2. View the video when thermal events are generated 

  3. View the areas in the video with bounding boxes where the thermal events were generated

  4. Get notifications (emails, Push notifications) when a thermal Event is generated

The model supported is AXIS Q1961-TE.


Setup of Thermal Camera: Axis Q1961-TE


Set up the camera: 

  1. Install the camera and add it to the network. Setup - https://help.axis.com/en-us/axis-q1961-te#install. Make sure that the camera is on the CAMLAN network of the bridge

  2. Use the same username/password for both ONVIF and Web/VAPIX.

  3. Search for the available cameras and add them as standard cameras to Brivo Eagle Eye Video. 




Set up Thermometry on the Camera:

  1. Set up thermometry in the Axis camera UI. You can log in to the camera using the Camera Tunnel via Brivo Eagle Eye Video dashboard. 

  2. Set up the Areas and rules on the Axis Camera UI - https://help.axis.com/en-us/axis-q1961-te#thermometry 

  3. All the rules and conditions are set up on the camera 


Enable Analytics on Brivo Eagle Eye Video:

  1. Enable Analytics on Brivo Eagle Eye Video: Log in and navigate to Camera Settings. Click Video analytics, change Thermal Camera Threshold Status to camera, and click Save Changes.


The Events and thereby the Alerts/Notifications that are generated whenever ANY of the conditions that were defined in the above step are met. We do not distinguish between types of conditions and do not indicate which specific condition triggered the event.


View Events on the History Browser:

After adding the camera and setting up thermometry, any new events generated (when the camera's conditions are met) will be visible in the history browser. The temperature and Bounding box for that event are also shown to indicate where the event was triggered. 


The display of bounding boxes and temperature is set up on the camera UI.


Set up Alerts for the Thermal Events:

You can set up Alerts and Notifications for a thermal event using the Alert Manager. First create an Alert Action for Email and/or Push. 



















Set up a rule for the Action:

Navigate to rules and then set up a rule to trigger the action on the Thermal Detection Event. 


After completing these steps, you'll get notifications (Push/Email) when the camera's conditions are met.


Limitations


  1. This only works with Axis Q1961-TE.

  2. The Events are only visible in the Enhanced Web interface and not in our Classic interface.

  3. The Bridge version should be 3.20 or later.